T-Peg with Cross Pin 40 cm, 1 pc - Yellow Passivated Steel for the Toughest Loads, Anchoring Awnings and Tents
- T-peg with cross pin, 40 cm, 1 pc: yellow passivated T-profile steel for the toughest loads. For awnings, tents and guy lines.
The T-peg with cross pin is 40 cm long and made of T-profile steel with a yellow passivated finish. It is a strong peg for awnings, tents and guy lines, for situations where ordinary wire pegs bend or do not hold. The cross pin near the head stops the loop or line, and the T-profile gives a large holding surface in the ground. The price covers one peg.

How the peg is built
The peg is made from steel section with a T-shaped cross-section. This profile is stiff and does not bend as easily as round wire when you drive it in. The lower end is cut to a point, so the peg enters the ground more easily. At the top there is a head for the hammer, with the cross pin just below it.
- T-profile steel
- length 40 cm
- pointed tip
- cross pin near the head for loops or lines
- yellow passivated finish that protects the steel against corrosion

What it is for
The manufacturer rates this peg for the toughest loads. It works well where the wind pulls hard on the fabric: at awning corners, storm guy lines, canopies and large tents. The longer the peg, the deeper it reaches and the better it holds in soft, sandy or soaked soil.
- caravan and motorhome awnings
- camping tents and gazebos
- storm straps for roll-out awnings
- sun sails and tarps

Driving in and pulling out
Drive the peg in at an angle of about 45 degrees, leaning away from the tent, so that the line pulls at a right angle to the peg. Use a camping hammer. Hook the loop or line under the cross pin so it cannot slip off the head. To pull it out, lever the peg by the pin with the hook of a peg puller or a second peg. On very hard, stony ground, rock pegs are the better choice.
Care and storage
After pulling the pegs out, clean off mud and sand and let wet pegs dry before packing them away. This keeps the finish protecting the steel for longer. Carry the pegs in a separate bag or box so the pointed tips cannot damage the awning or tent fabric. A peg bent by a stone can usually be straightened, but if the profile is cracked, replace it.
Other lengths and sets
The same peg is available in several lengths.
Key data at a glance
| Feature | Value |
|---|---|
| Type | T-peg with cross pin |
| Material | steel |
| Finish | yellow passivated |
| Length | 40 cm |
| Load rating | for the toughest loads |
| Quantity | 1 pc |
Questions and answers
What ground is this peg suitable for?
For typical campsite ground: grass, soil, sand and soaked ground. On rock and very stony ground, rock pegs are better.
What is the cross pin for?
It holds the loop or line so it cannot slip off the head, and makes it easier to pull the peg out of the ground.
How many pegs are included?
The price includes 1 peg, 40 cm long.
Which length should I choose?
30 cm is enough in firm soil. 40 cm and 50 cm hold better in sand, soft or soaked ground and in strong wind.









