Tripus Wheel Chock Holder Black, Polyethylene, Snap-In, for Trailers and Motorhomes - Chock Holder with 4-Screw Fixing
- Tripus holder for UK200 wheel chocks in black, polyethylene with snap catch. About 167 x 95 x 20 mm, 40 g, fixed with 4 screws at 40 x 40 mm spacing.
The Tripus wheel chock holder in black gives the chock a fixed place on the trailer frame or drawbar, in a locker or in the boot of a motorhome. The chock slides in and is held by a snap catch, so it stays put while driving and does not go missing. The one-piece polyethylene holder measures about 167 x 95 x 20 mm and weighs about 40 g.

Tidy and always at hand
Under §41 StVZO, trailers with a permitted total weight above 750 kg must carry two wheel chocks. The holder keeps the chock in the same place every time, ready to be pulled out in one move when the trailer stops on a slope. The patented one-piece design has no separate parts that could go missing. The holder is TÜV tested.

Fitting with 4 screws
The holder has 4 through holes of 6 mm diameter arranged in a 40 x 40 mm square. Choose a flat, load-bearing surface such as the trailer frame, the gas locker wall or a storage compartment wall, and use screws that suit the material. Before drilling, check that the chock can be slid in and out freely.
- 4 holes Ø 6 mm at 40 x 40 mm spacing
- Flat, load-bearing mounting surface
- Screws matched to the surface
For Tripus UK200 chocks
The holder is designed for Tripus UK200 chocks, for example the Tripus UK200 chock in black. The chock itself is not part of this offer, and the load rating comes from the chock, not from the holder.
Key data at a glance
| Feature | Value |
|---|---|
| Brand | Tripus |
| Type | wheel chock holder |
| Colour | black |
| Material | polyethylene |
| Dimensions (L x W x H) | approx. 167 x 95 x 20 mm |
| Weight | approx. 40 g |
| Fixing | 4 through holes Ø 6 mm, 40 x 40 mm spacing |
| Fits | Tripus UK200 chocks |
| Testing | TÜV |
| Quantity | 1 holder, without chock |
Questions and answers
Is the chock included?
No, this offer covers the holder only. The Tripus UK200 chock is available as a separate product.
How many holders do I need?
Usually two, because a trailer above 750 kg carries two chocks and each chock has its own holder.
Where is the best place to fit the holder?
On a flat, load-bearing surface that is easy to reach when you stop, such as the trailer frame, the drawbar or a locker wall.







