VOTRONIC Waste Water Tank Display S 5313 - 12/24 V, 10 LEDs - motorhome and boat grey water tank
- VOTRONIC Waste Water Tank Display S (no. 5313): a 10-LED light bar in 3 colours shows the waste water level steplessly. 12/24 V (10-32 V), 85 x 47 x 20 mm, cut-out 63 x 29 mm, auto switch-off after 10 min. Requires a Votronic tank sender.
The VOTRONIC Waste Water Tank Display S (article no. 5313) is a panel tank level display for waste water (grey water) tanks in motorhomes, caravans and boats. The level is shown by a 10-LED light bar in three colours. The display is stepless: intermediate levels are shown by varying LED brightness, so the reading is finer than with typical stepped displays. It works in 12 V and 24 V systems and with tanks of any material and size, provided a suitable Votronic capacitive tank sender is connected. As part of the S series it matches other Votronic S panels, such as the battery tester, LCD displays and switch and fuse panels.
Key features
- 10-LED light bar in 3 colours with stepless level display
- for waste water (grey water) tanks in motorhomes, caravans and boats
- for tanks of all materials and sizes (with a suitable sender)
- 12/24 V DC supply, operating range 10-32 V
- flat electronics only 14 mm deep, easy panel mounting
- 100% test at the push of a button and automatic switch-off after 10 minutes
- electronic protection against reverse polarity, overload and short circuit
Operation
- press the button: all LEDs light briefly (100% test), then the current level is shown
- press again to switch off
- with an empty tank the lowest LED glows dimly, so you can see the display is working
- after 10 minutes the display switches off by itself and does not drain the battery
Compatible Votronic senders
- Tank Electrode 12-24 K (no. 5543) - top or bottom mounting, tanks 12-24 cm, in our shop: capacitive sender K 12-24 cm
- Tank Electrode 15-50 K (no. 5545) - top or bottom mounting, tanks 15-50 cm, in our shop: capacitive sender K 15-50 cm
- Tank Electrode 25-75 K (no. 5549) - top or bottom mounting, tanks 25-75 cm, in our shop: capacitive sender K 25-75 cm
- Tank Electrode 20 K-WC (no. 5555) - top mounting, tanks 12-24 cm
- Tank Electrode 30-110 K-FL (no. 5551) - top mounting, tanks 30-110 cm
- Tank Sensor FL (no. 5530) - side or top mounting, tanks 30-100 cm
- older Votronic senders no. 5510 and 5520 are not intended for this display
- one sender is needed per tank
Installation, wiring and related products
- panel cut-out slightly larger than 29 x 62 mm, the panel is fixed with the screws supplied
- cover the rear opening of the panel with insulating material
- terminals: 1 - battery minus, 2 - battery plus, 4 - sender signal, 5 - sender supply (plus, switched)
- cable cross-section 0.5-1.5 mm², terminal tightening torque 0.5 Nm
- manufacturer tip: two tanks can share one display via a 2 x UM switch (e.g. Votronic switch panel 16 A S, no. 1289, or 2 x 16 A S, no. 1291)
- do not clean the panel with solvents
- also see: VOTRONIC fresh water tank display S (5311), VOTRONIC black water tank display S (5315), VOTRONIC Info Panel Pro
Technical data
| Parameter | Value |
|---|---|
| Manufacturer | Votronic |
| Model | Waste Water Tank Display S |
| Manufacturer article number | 5313 |
| Application | waste water (grey water) tanks in motorhomes, caravans and boats |
| Display | 10-LED light bar, 3 colours, stepless |
| Supply voltage | 12/24 V DC (range 10-32 V) |
| Current consumption | 1 mA off, max. 30 mA at 100% display |
| Sender supply output (terminal 5) | 10-32 V, max. 120 mA |
| Protection | reverse polarity, overload, short circuit |
| Automatic switch-off | after 10 minutes |
| Dimensions | 85 x 47 x 20 mm |
| Panel cut-out | 63 x 29 mm |
| Installation depth | 18 mm |
| Weight | 28 g |
| Compatible senders | Votronic 5543, 5545, 5549, 5555, 5551, 5530 |
| Scope of delivery | display, 4 screws, manual |
| Country of manufacture | Germany |
Questions and answers
Does the display work without a sender?
No. A Votronic capacitive tank sender is required, e.g. sender K 15-50 cm (no. 5545) or K 12-24 cm (no. 5543), chosen to match the tank height.
Is it suitable for 24 V systems?
Yes. The display works at 12 V and 24 V, in the range 10-32 V.
Does the display drain the battery?
When off it draws about 1 mA, and once switched on it turns itself off after 10 minutes.
Does it work with a metal tank?
Yes. The display works with tanks of all materials, provided a suitable Votronic sender is used.
Manufacturer
VOTRONIC Elektronik-Systeme GmbH, Johann-Friedrich-Diehm-Str. 2, 36341 Lauterbach, Germany.